Figure1(Final Model)
Step1: Select the workbench
1.Launch solidworks2009
2.Select Start>new >a 3d representation.of a singe desinge compoent
3.Save file .Rename PartBody ” A Rounded Control Switch”
Step2:Draw the bottom of “A Rounded Control Switch”
1.Set the workbenth “front plane",and click theicon.Creat a new sketch1 (or click the
icon) with line
icon ,centerline
icon ,centrepoimt arc
icon, trim entities
icon and smart dimension
icon.Look at Figure2. Don’t forget to quit the sketch workbench.
Figure2
2.Revovle.Set the sketch2. The path: insert>Boss/Base >Revovle (or click the Revovle icon in the feature toolbar). All is shown in Figure3 and Figure4.
Figure3 Figure4
3.Creat a new reference plane as shown in Figure5. The path : insert>reference geometry>plane.Set the acquiescent direction.Look at the Figure5.
Figure5
4.Repeat the third.Creat a new reference plane as shown in Figure6. The path : insert>reference geometry>plane.Set the reverse direction.Look at the Figure6.
Figure6
5.Set the workbenth “front plane",and click theicon.Creat a new sketch2 (or click the
icon) with line
icon ,centerline
icon , three point arc
icon, trim entities
icon and smart dimension
icon.Look at Figure7. Don’t forget to quit the sketch workbench.
http://www.cadfamily.com/html/Article/Rounded%20Control%20Switch%20in%20SolidWorks_520_1.htm
http://www.cadfamily.com/html/Article/Rounded%20Control%20Switch%20in%20SolidWorks_520_2.htm
http://www.cadfamily.com/html/Article/Rounded%20Control%20Switch%20in%20SolidWorks_520_3.htm
No comments:
Post a Comment