AutoForm Forming Symmetrical Double-Attached Parts with Two Drawing Operations

http://www.cadfamily.com/HTML/Article/AutoForm%20Forming%20Symmetrical%20Double-Attached%20Parts%20with%20Two%20Drawing%20Operations_445.htm
This lesson addresses the issue of multi-stage drawing in the form of a two-stage drawing process. For these two drawing stages, the left-hand part is folded up with the symmetrical right-hand part fa a single drawing stage. After the second drawing operation, the separation of the single parts and fhe subsequent flanging are calculated, Finally, the cut line is optimized with AutoForm-Trim,


Main Focus
Two-stage drawing
Generating geometry stages for two symmetrical parts in AutoForm-DieDesigner
Morphing
Optimizing cut line


Used Software
AutoForm-DieDesigner
AutoForm Incremental
AutoForm-Blank generator
AutoForm-Trim