Display in SolidWorks

Figure1(Final Model)

Step1: Select the workbench

1.Launch solidworks2009

2.Select Start>new >a 3d representation.of a singe desinge compoent

3.Save file .Rename PartBody ”Display”

Step2:Draw the bottom of “Display”

1.Set the workbenth “front plane",and click theicon.Creat a new sketch1 (or click the icon) with center rectangleicon and smart dimension icon.Look at Figure2. Don’t forget to quit the sketch workbench.

 

Figure2

2.Extrude1.Extrude the sketch1. The path: insert>Boss/Base >Extrude (or click the boss/base Extrudeicon in the feature toolbar). Be care the direction. Take acquiescent direction.Select’Blind’in the termination conditions as shown in Figure3 .

 

Figure3

3.Set the workbenth “top plane",and click theicon.Creat a new sketch2 (or click the icon) with line icon, centerline icon, three point arc icon and smart dimension icon.Look at Figure4. Don’t forget to quit the sketch workbench.

 

Figure4

4.Cut-Revovle1.Set the sketch2. The path: insert>Cut >Revovle (or click the cut

Revovle icon in the feature toolbar). All numble is shown in Figure5 and

Figure6. Take acquiescent direction.

 

Figure5 Figure6

5.Set the workbenth “right plane",and click theicon.Creat a new sketch3 (or click the icon) with line icon, centerline icon, three point arc icon and smart dimension icon.Look at Figure7. Don’t forget to quit the sketch workbench.

 

Figure7

6.Cut-Extrude. The path: insert>Cut>Extrude (or click the Extrude icon in the Feature toolbar). Select’Through All’in the two termination conditions as shown in Figure8.

 

Figure9 Figure10

7.Set the workbenth “top plane",and click theicon.Creat a new sketch4 (or click the icon) with line icon, centerline icon, three point arc icon and smart dimension icon.Look at Figure10. Don’t forget to quit the sketch workbench.

 

Figure10

8. Cut-Extrude. The path: insert>Cut>Extrude (or click the Extrude icon in the Feature toolbar). Select’Through All’in the two termination conditions as shown in Figure11.

Figure11 Figure12

9.Creat the Mirror of cut-Extrude3. The path:insert>Pattern/ Mirror>Mirror (Or click the icon in the surface tolbar).Look at the Figure13.

http://www.cadfamily.com/html/Article/Display%20in%20SolidWorks_525_1.htm