1. Launch UG.
2. Click icon, select Model and input name “Cylinder”.
3. Click icon, then click
icon to create a sketch as shown in Figure1, then click
icon.
Figure1
4. Click icon, select the sketch created last step as the curve to extrude, and edit as shown in Figure 2, then click
icon.
Figure 2
5. Click icon, then click
icon, then click the yellow face as the planar placement face and select the red curve as the horizontal reference as shown in Figure 3, then edit as shown in Figure 4, then click
icon, then click
icon, select the ZC as the
Figure 3 Figure 4
target edge and select the red curve as the tool edge as shown in Figure 5, then edit as shown in Figure 6, and then click icon.
Figure 5 Figure 7
Figure 6
Then click icon, and select the YC as the target edge and select the red curve as the tool edge as shown in Figure 7, then edit as shown in Figure 8, and then click
icon.
Figure 8
6. Click icon, then select the yellow face as the sketch plane as shown in Figure 9, then click
icon to create a sketch as shown in Figure10, then click
icon.
Figure 9
Figure10
http://www.cadfamily.com/html/Article/Outrigger%20in%20UG_NX_509_1.htm
No comments:
Post a Comment