Figure1(Final Model)
Step1: Select the workbench
1.Launch solidworks2009
2.Select Start>new >a 3d representation.of a singe desinge compoent
3.Save file .Rename PartBody ” Descrition”
Step2:Draw the bottom of “Descrition”
1.Set the workbenth “front plane",and click theicon.Creat a new sketch1 (or click the
icon) with line
icon circle
icon , trim entities
icon and smart dimension
icon.Look at Figure2. Don’t forget to quit the sketch workbench.
Figure2
2.Extrude1.Extrude the sketch1. The path: insert>Boss/Base >Extrude (or click the boss/base Extrudeicon in the feature toolbar). Be care the direction. Take acquiescent direction.Select’Mid Plane’in the termination conditions as shown in Figure3 .
Figure3
3.Set the workbenth “top plane",and click theicon.Creat a new sketch2 (or click the
icon) with center rectangle
icon and smart dimension
icon.Look at Figure4. Don’t forget to quit the sketch workbench.
Figure4
4.Set the workbenth “front plane",and click theicon.Creat a new sketch1 (or click the
icon) with line
icon circle
icon , trim entities
icon and smart dimension
icon.Look at Figure2. Don’t forget to quit the sketch workbench.
Figure5
5.Sweep the sketch2 and the sketch3. The path: insert>Feature >Sweep (or click the Feature Sweep icon in the Feature toolbar).All is shown in Figure6 and Figure7.
Figure6 Figure7
6.Creat a new reference plane1. Click the face1(shown in the Figure9) and next click. The path : insert>reference geometry>plane
.Set the acquiescent direction.Look at the Figure8 and Figure9.
http://www.cadfamily.com/html/Article/Descrition%20in%20SolidWorks_491_1.htm
http://www.cadfamily.com/html/Article/Descrition%20in%20SolidWorks_491_2.htm
http://www.cadfamily.com/html/Article/Descrition%20in%20SolidWorks_491_3.htm
No comments:
Post a Comment