Inserting a Rough Cutting Cycle
The Advanced Rough command is a roughing cycle for removing material from a defined
stock by making a series of parallel or profile cuts across the stock at different Z axis depth
levels.
Depending on the options selected, the toolpath retracts and pierces between cuts at each Z
axis level or the toolpath stays down at the Z axis depth level following the 2D contour of
the surface with continuous cutting, then retracts and pierces to the next level of lacing.
Rough Cut cycles support end mill, hog nose, ball nose and taper tools.
Generating a Rough Cutting Cycle on a Core Part
In this exercise, you generate the rough cut toolpaths for a core (male) part, then you edit the
operation and generate toolpaths using different parameter values.
No comments:
Post a Comment