Diestress-wizard_lab1

http://www.cadfamily.com/a/CAE_FEA_CFD/Forge-CAST/Diestress-wizard-lab1_4143.html

1.1.Problem Summary:
The DieStress Analysis-3D is a convenient tool to set up and do a die stress analysis.
This lab will demonstrate how to run a die stress analysis in die stress wizard. When the
stress analysis is being done on only one tool, a one step simulation is sufficient to get
accurate stresses. When the stress analysis is being done on die assemblies where there is
interaction between the tools, more than one step is typically needed for the die stack to
come to a state of equilibrium under the applied load.
In a typical die stress simulation, the workpiece is removed and the forces exerted onto
the dies by the workpiece are interpolated onto the tools. In this lab, a shrink fit will also
be modeled.