2D_Lab12_SpikeNonIsothermal

http://www.cadfamily.com/a/CAE_FEA_CFD/Forge-CAST/2D-Lab12-SpikeNonIsothermal_4062.html

1 2. Spike Forging - Non-Isothermal
1 2.1 . Opening a Previous Simulation
The DEFORM-2D MAIN window should already be open. In Lab 6, after we had meshed a billet
and two dies, the file Spike_NonIsothermal.KEY was saved in the Spike directory. We will now
finish the setup of that problem and run a non-isothermal forging simulation.
Open the Spike directory, highlight the file Spike_NonIsothermal.KEY in the file list and click
to open the Pre-processor.
1 2.2. Setting Simulation Controls
Click to enter SIMULATION CONTROLS.
In the menu, set the Number ofSimulation Steps to 100 and the Step Increment to Save
to 5. Set the Primary Die to Top Die since it is the Top Die that will be moving, and under
Solution Steps Definition, set With Constant Die Displacement to 0.015".