Deform2d_Diestress_Lab

http://www.cadfamily.com/a/CAE_FEA_CFD/Forge-CAST/Deform2d-Diestress-Lab_4081.html

1.1 Problem Summary
The DieStress Analysis-2D is a convenient tool to set up and do a die stress
analysis. This lab will demonstrate how to run a die stress analysis in die stress
wizard. When the stress analysis is being done on only one tool, a one step
simulation is sufficient to get accurate stresses. When the stress analysis is
being done on die assemblies where there is interaction between the tools,
more than one step is typically needed for the die stack to come to a state of
equilibrium under the applied load.
In a typical die stress simulation, the workpiece is removed and the forces
exerted onto the dies by the workpiece are interpolated onto the tools. In this
lab, a shrink fit will also be modeled.