Polygons
The Polygon command on the CAD toolbar allows you to insert boxes, rectangles,
octagons, etc. A polygon can have from three sides up to whatever number of sides you
need. The most common use for this command is to draw squares and rectangles.
Inserting a Polygon with Known Corners
The Corner Points modifier allows you to insert a polygon by defining two points at opposite
corners. These corners can have known X and Y positions or you can use any of the Snap
commands to define the corners. Typically, this modifier is used for inserting squares and
rectangles. When you use the Corner Points modifier, the polygon is inserted in the current
Cplane only. To insert a polygon on a plane other than the current construction plane, use the
Three Point Definition modifier.
No comments:
Post a Comment