Setting the scanning parameters controls how the laser probe records
point cloud data to PowerINSPECT.
To access the parameters for the particular laser probe, you must first
ensure that the laser probe is the active probe on the arm.
You set the parameters by clicking on the Machine toolbar (see
page 3) and then configuring them according to the type of feature being
measured:
ƒ when inspecting geometric features, you are advised to use
unfiltered points (100% density):
ƒ when inspecting surfaces, you are advised to use points filtered to
approximately 25%.
Experiment with the settings to discover what works best for you
No comments:
Post a Comment