Task 1. Creat front view
Step 1.Draw the center line shown in Figure 1.
(1) Swich layer. In the ‘Layer Manager’ toolbar, choose the ‘center line’ layer. Make sure the 
(Ortho Mode) and 
(Object Snap) in the state bar is on.
(2) Choose the pull-down menu (Ortho Mode) and (Object Snap) in the state bar is on.
→
, draw three center lines shown in Figure 1. The length is 200.The two horizontal center line are on the same level.
Step 2. Draw circles shown in Figure 2
(1) Swich layer. In the ‘Layer Manager’ toolbar, choose the ‘Profile Line’ layer .
(2) In the state bar, click the 
button (Show/Hide Lineweight ), the Show/Hide Lineweight mode will be on.
button (Show/Hide Lineweight ), the Show/Hide Lineweight mode will be on.
Get free full Tutorial!
Please send me email:
cadxneter@hotmail.com
No comments:
Post a Comment