http://www.cadfamily.com/downinfo/300513.html
4.6.6. Drag Icon Description This command allows you to move the image in the Working Window by dragging it with a mouse.
Syntax By clicking on the DRAG icon the toggle button is activated and the image can be moved by holding in the left mouse button and moving it inside the Working Window. Related Topics DISPLAY TOOLS, RESTORE, ZOOM
Use this toggle switch to isolate a subset of the geometry as the active set. This enables you to work on the "clipped" portion of the geometry without the distraction of the complete model being in the Working Window. Syntax By clicking with the left (or the right) mouse button on the CLIP icon the toggle button is activated.
After the CLIP icon is activated, by holding in the left mouse button and moving the mouse to create a drag box around a portion of geometry will activate this enclosed geometry in the drag box, when the button is released.
The two CLIP possibilities which are available in the Meshing or QUALITY CHECKING ENVIRONMENT and are listed as follows: • If the CLIP button is activated by clicking with the left mouse button then the mesh in the selected drag box is activated (figure on the left, below); • If the CLIP button is activated by clicking with the right mouse button then the mesh in the selected drag box is removed and all the elements that fall outside of this box is activated (figure on the right, below).
No comments:
Post a Comment