http://www.cadfamily.com/downinfo/302565.html
The Spectrum Digital Low Voltage Adapter with Adaptive Clocking provides the following:
•Voltage translation between 3.3-volt emulator interfaces and JTAG targets that require down to 1.8-volt
interfaces
•Adaptive clocking for TI ARM based processors
The adapter is designed primarily to support the XDS510USB emulator but may be used with most any emulator that
supports the standard TI 14-pin JTAG header.
To get started simply plug the Low Voltage adapter into your emulator??s 14-pin cable connector. Then plug the other end into your target.Both the male header and female connector on the Low Voltage adapter are keyed to prevent incorrect insertion.The diagram below shows a side view of the connection to the board.
No comments:
Post a Comment