Installing the J-Link ARM software and documentation
J-Link is shipped with a bundle of applications, corresponding manuals and some example projects, and the kernel
mode J-Link USB driver. Some of the applications require an additional license.
Refer to chapter J-Link and J-Trace related software on page 21 for an overview about the J-Link software and
documentation pack.
SETUP PROCEDURE
To install the J-Link software and documentation, follow this procedure:
Note:Check for J-Link related downloads on our website:
http://www.iar.com/jlinkarm
1 Connect your computer and the J-Link debug probe using the USB cable. Do not connect the J-Link debug probe to
the evaluation board, yet. The green LED on the front panel of the J-Link debug probe will blink for a few moments
while Windows searches for a USB driver.
No comments:
Post a Comment