Workshop 9.1–Goals
Goal:
-Use the Workbench Parameter Manager (available from the Project page) to setup multiple scenarios and solve all at one time.
Workshop 9.1–Project Schematic
Open the Project page.
From the Units menu verify:
-Project units are set to “Metric (kg, mm, s, C, mA, mV).
-“Display Values in Project Units” is checked (on).
1.From the Toolbox double click “Static Structural” to create a new system.
2.RMB the geometry cell and “Import Geometry” and browse to “Lever.x_t”.
3.Double click the “Model” cell to open the Mechanical application.
4.Set the working unit system:
“Units > Metric (mm, kg, N, s, mV, mA)”.
5.Apply constraints to the model (highlight “Static Structural” branch (A5):
a.Select the surface of the large hole.
b.RMB > Insert > Cylindrical Support.
c.In the detail window change the “Tangential” constraint to “Free”.
d.Highlight the bottom face of the vertical cylinder.
e.RMB > Insert > Fixed Support.
6.Apply Loads to the model:
a.Select the surface of the smaller hole shown below.
b.RMB > Insert > Bearing Load.
c.In the Details of “Bearing Load”, switch to the component method.
d.Enter a magnitude of 5000 N in the Y direction.
e.Toggle the ‘P’ next to “Y Component” to flag the load as parametric.
http://www.cadfamily.com/html/Article/Parameter%20Management_700_1.htm
http://www.cadfamily.com/html/Article/Parameter%20Management_700_2.htm
No comments:
Post a Comment