UniSim Design User Guide

http://www.cadfamily.com/downinfo/300355.html
8.2.22 Defining a Baghouse Filter
1. Add a baghouse filter to your simulation.
2. Click the Design tab, then select the Connections page.
3. In the Inlet drop-down list, select a pre-defined stream or click the space at the top of the list and type the stream name.
4. In the Vapour Outlet drop-down list, select a pre-defined stream or click the space at the top of the list and type the stream name.
5. In the Solid Outlet drop-down list, select a pre-defined stream or click the space at the top of the list and type the stream name.

When all of the attached streams are properly defined, the status bar at the bottom of the property view turns green and displays the message Ok.

If the baghouse filter cannot solve, the status bar is yellow and displays the requirements needed to solve.