http://www.cadfamily.com/downinfo/300351.html
Number of gatesThe number of gates used is based on the pressure to fill the cavity. In general, the minimum number of gates to fill the cavity is selected.Position of gatesThe position of the gate is determined by the flow balancing principle.Flow patternThe mold should fill with a straight fill pattern with no changes in direction during filling.
Runner DesignThe runner system is designed to achieve the required filling pattern in the cavity.Sequence of AnalysisThe procedure of the mold design always starts with the cavity.
Determine the design criteria for the projectUse previous experience of analystDiscuss the project with all disciplines involved in the projectUse Moldflow Design PrinciplesUse Moldflow Design Rules with the softwareInterpret results and make changes where necessaryDiscuss changes with all disciplines involved in the projectRepeat Moldflow analysis to ensure acceptable results
No comments:
Post a Comment