INTRODUCTION
From it’s inception, EnSight has been used extensively to postprocess time-varying or transient data. In many cases,
dynamic phenomena can only be understood through interactive exploration. The Solution Time Quick Interaction
area provides the interface for working with transient data and provides comprehensive control over time handling.
BASIC OPERATION
EnSight provides two ways to work with transient data. By default, time is presented as a series of discrete steps
running from zero to the total number of steps minus one. However, you can also present time based on the actual
simulation time values found in your results data. The presentation mode is controlled by the Time As pulldown
menu. In the dialog below, Time As is set to Step and time is presented as discrete steps running from 0 to 159 (160
total steps). The simulation time (as reported in the top line of the dialog) runs from 1.0 to 160.0.
The current time range is displayed in the Beg and End fields with the current time step shown in the Cur field. You
can modify the time range displayed in the slider by editing the Beg and/or End fields (remember to press return).
You can change the current time step by editing the Cur field (press return), manipulating the slider, or clicking the
left/right slider arrows. Clicking Reset Time Range will reset Beg and End to the full range.
No comments:
Post a Comment